This IR an RGB DMX 512 decoder /controller; uses advanced micro-chip control technology, it converts DMX512 signal to drive "analog" Led Strips. Has 3 output channels, 256-level brightness control. Can be connected with a DMX based output/console or any intelligent DMX building module and decode DMX signals to control led strips. Can also be used without DMX512 using the built-in programs and IR controller.

Compatible with DMX512/1990
 
Support IR remote control (included)
  
256-level brightness, full-color control 
   
3 X RGB Channel, 5A max. each
   
256 grey level, no flickering due to PWM
   
5 built-in color-changing programs
   
Can drive 1 to 3 channel of led strips
   
DMX start address setup
     

Dimensions(L*W*H): 178.0*41.1*32.7mm
     
Channel: 3
 
Input Signal: DMX-512/1990 digital signal
 
Output Signal: 0~100% PWM dimming signal, can drive 5A(Each CH.)
  
Power Supply: DC12V/24V
   
Power Output: <200W
   
Remote Control Range: 10m

 

User instructions:

DMX mode: Press this to turn to DMX operation

P1-P5: 5 pre-saved programs

P1: 7 colors, press to change color (RED, GREEN, BLUE, ORANGE,YELLOW,CYAN,PURPLE)

P2: Full color change, color sequence: R->RG->G->GB->B->RG->R

P3: Full color change, color sequence: R->RGB->B->RB->RGB->RG->G->RGB->RB->R

P4: Full color change, color sequence: B->R->G->B

P5: Full color change color sequence: Black->R->Black->G->Black->B->Black

LOCK: Freeze to current color

FADE: Shift color changing programs for fade or flash mode (P2-P5 only)

BRIGHTNESS: 16-level brightness adjust for pre-saved program

+: Brightness increase 1 level

-: Brightness decrease 1 level

SPEED: 16-level speed adjust for pre-saved program

+: Speed increase 1 level

-: Speed decrease 1 level

Package Includes the following:

1 x main DMX IR controller module
   

1 x remote controller with battery
   

1 x RJ-45 cable(2m)
   

1 X 4-pin male and female connector for RGB LED strip
   

1 x DC connector

Notes:

DMX RGB Led controller can decode dmx-512 signal from any console or intelligent lighting module based on dmx512; can drive 3 channels of RGB Led strip or any similar constant voltage product.

• Can drive up to 20 meters of RGB Led Strip (150Leds/5 meters reel).

• Can drive up to 10 meters of RGB Led Strip (300 Leds/5 meters reel).

• DMX-512 input connection is by RJ45 plug; you may simply much the 3 dmx wires coming out from the RJ45 with an XLR 3 pins or 5 pins plug or whatever plug your application may use. Its a very simple procedure and a connection diagram is printed into the controller it self.

Product Reviews

Write an online review and share your thoughts.