|
Chromoflex III RC RGB Led controller (Dimmable)
This is just the controller, wireless remote or wireless USB dongle sold separetely!
Chromoflex III RC is an excellent value full colour control and was designed for use with modern High-Power RGB LEDs.
There are currently two Chromoflex III RC models available i350 for use with constant current LEDs and STRIPE for use with LED strips. The Chromoflex RC is able to synthesise up to 16 millions of different colours. Hence it is the ideal control for all kind of sophisticated effect illuminations, deco and wellness lighting.
Chromoflex III RC is a further development of the Chromoflex I and II series. The acronym RC stands for Radio Controlled.
Thats why either a handheld Chromoflex Radio Remote Control or the Chromoflex USB Dongle (for PC) is required additionally to this Chromoflex RC module.
The Chromoflex RC was designed for easy use. It comes with many built in effects (from calming colour change, up to show effects). However, the user can change and store many own settings. Up to 8 different wireless networks can be operated simultaneously. The colour changes and static colours of the modules within a network are synchronised automatically (but random effects of course not). The range of the radio transmission is depending on the environment, but can be up to 300 meters in open air. Indoors normally a reliable operation within 20-50 meters is no problem.
Networking and wireless operation
The Chomoflex RC is working on a radio frequency of 868.3 MHz. This frequency is also often used for other radio controls and wireless sensors (but the very strictly valid regulation ensure, that interference free operation is possible).
Hence the Chromoflex RC uses a 2-way communication to ensure reliable operation, this means the handheld Radio Remote Control or the USB Dongle require an acknowledge from the Chromoflex RC!
In the simplest case only one Chomoflex RC is used with a handheld Radio Remote Control or an USB Dongle. So this is really an obvious 2-way communication. It is only required that both partners are set to the same network (1-8). This is also the default factory setup mode (default: network 8).
If a group of more than one modules build one network, one module within the network should be set up as a Master module. Only the Master will communicate with the Handheld Radio Remote Control or the USB Dongle. But it will forward its settings (and its time base) periodically (all few seconds) or on a communication event to all other modules within the network. Even if other modules (non-Master) are switched on later, they will receive (at least after a few seconds) the settings from the Master.
Warning! Large file size. Depending on your connection, the page may be slow to open.
Alternatively you can right click here and choose "Save Target As".
|
Product Brochure
